SS-16 VoIP-2-GSM USER MANUAL
DOC. NO: SS-16-14 (REV. 02)
Page 37 of 84
Click “Edit” or “More” to edit the settings on the specific interface:
Volume
One can modify the sound level both for the output –
TX and input – RX of the voice channel. Select
Volume to change the audio level for
input
and
output.
The default is -8 db.
One may use the "Default" button located at the bottom of the page to
restore the default level for both input and/or output.
Definition of RX and TX
In this page for Mobile Settings, RX is the voice path coming form the mobile network
towards VoIP, while TX is the reciprocal voice path, which comes from VoIP towards
the mobile network.
Note1
: Don’t forget to use the button “
Save
” to store the changes performed over the
audio volume.
Note2:
The audio volume can be set up only when the State of the Mobile module is
ready (registered but not busy).
If the module was busy dialling a number, or sending / receiving SMS messages, it is
not available for
interrogation
, so the request to set a different audio level will not be
applied.
Note3
: Do
not change the audio level parameters unless necessary, as this may
affect the voice quality.
CLIR
– This setting allows the user to present or withheld the Caller ID.
There are thee option:
Network - The CLI setting is determined by the network
Yes – (CLIR is ON) The identity of the call will
not
be sent (identity restricted).
No – (CLIR is OFF) The identity of the call will be sent.
