SS-16 VoIP-2-GSM USER MANUAL
DOC. NO: SS-16-14 (REV. 02)
Page 11 of 84
•
To ensure good coverage of the entire wireless mobile network in the area, SS-16
VOIP-2-GSM should be installed in a central place in the building. Normally the
antennas should be in a vertical position, but if reflections occur, better results may
be achieved by changing the orientation.
•
For power supply, use only the adapter shipped with SS-16 VOIP-2-GSM. The
jacks of different power supplies may fit but the polarity, current, voltage or
regulation factor may not be compatible.
•
While the device is in operation, the antennas of the SS-16 VOIP-2-GSM unit
should be at least 30 centimetres away from any human being.
5.2
MOUNTING (HARDWARE INSTALLATION)
Figure 1. Mounting SS-16 VOIP-2-GSM on a wall
The SS Telecoms SS-16 VOIP-2-GSM router may be mounted either horizontally, by
means of simply placing it on a flat surface, or vertically on a wall (Using a mounting
bracket Available from SS Telecoms).
Horizontal mounting
The surface must be level and strong enough to hold the weight of SS-16 VOIP-2-
GSM together with all its cables (power supply and wired LAN connection). A desk,
table or shelf is good place for the installation of SS-16 VOIP-2-GSM.
Wall mounting (Recommended)
The equipment may also be mounted on a wall. On the left side, there is a pair of
mounting holes to secure the SS-16 VOIP-2-GSM to the wall.
The mobile antenna must be in an upright vertical position.
Installing SS-16 VOIP-2-GSM on a shelf higher up, with no obstructions around,
ensures the best performance embedded modems.
Take care to ensure adequate cooling of the SS-16 VOIP-2-GSM terminal.
