SS-16 VoIP-2-GSM USER MANUAL
DOC. NO: SS-16-14 (REV. 02)
Page 31 of 84
Net
: Address of the remote network or host to which the user wants to assign a static
route. Notice that it is not an IP address, like the one for the SS Telecoms SS-16
device, but the address of a network, so that the last two groups of figures will always
be zero.
Netmask
: the subnet mask determines which portion of the destination IP address is
the network part and which is the host part.
Gateway
: the gateway to be used, enter here the IP address of the router which
allows for contact between SS-16 VOIP-2-GSM and the remote host or network.
Enable:
Each of the routes defined or edited can be individually enabled or disabled.
This is especially useful when configuring several SS-16 VOIP-2-GSM devices one
after another, or when the configuration and requirements of the local network change
frequently.
In this case pre-define several routes, even if they are not currently in use, and leave
enabled only the ones strictly necessary for the current configuration.
The other routes are available; they may be edited and enabled as the need arises.
6.3.4
Commit
The “Commit” option described here is not specific to the Network, but it is rather a
general option for SS Telecoms devices.
If configuration changes were performed, using the “Save” button is not enough since it
saves the modifications only into the temporary memory of the SS-16 VOIP-2-GSM.
Always press the “Commit” button if these changes need to be permanent.
This button is located at the bottom of the Menu list, to the left side of the screen.
There is a “Commit Settings” message and, underneath it, a red progress bar over black
background which says: “Saving changes, please wait …”
Saving will take some time, because the changed settings are saved into permanent
(Flash) memory of the equipment.
The SS-16 VOIP-2-GSM resets, and when it starts again, the new set of parameters will
be active.
Warning:
While committing changes, when resetting the SS-16 VOIP-2-GSM or
while loading a new program image, the equipment will cease operation for a
few seconds. This means all connections: voice, local network etc. will be
interrupted, but will resume when the SS-16 VOIP-2-GSM starts again.
