SPX Waukesha Cherry-Burrell Votator II, Operation And Maintenance Manual

Page: 49 / 84

Waukesha Cherry-Burrell Maintenance
October 2005 95-03057 Page 49
7. The head has an ON-OFF engraving on the rim,
located just above product outlet. Rotate head in OFF
direction until head disengages.
8. Lower head until hydraulic rod is fully extended. See
Figure 38.
9. Once shaft is in down position, blades may be
removed from shaft.
NOTE:
Blades should be kept in the same position on
mutator shaft throughout life of blade. Make sure blades
are removed and reinstalled in the same location on shaft.
10. If shaft is to be removed from unit, lift head and shaft
off lift pin and move head away from unit while a
second person guides spline end of shaft out of unit.
11. Place shaft and head assembly on a table or suitable
frame for servicing.
12. Scraper blades can be removed and serviced at this
time.
Shaft Installation - Vertical Unit
1. Assemble head to shaft.
2. Slide splined end of shaft into unit.
3. Lift head onto lift pin.
4. Install scraper blades.
NOTE:
Blades should be kept in the same position on
mutator shaft throughout life of blade. Make sure blades
are removed and reinstalled in the same location on shaft.
5. If optional blade aligning tool is used, install it on the
bayonet ring of heat transfer tube. Place each half of
the ring on the bayonet and rotate it as one piece.
Figure 38- Shaft Fully Extended
Figure 39 - Head Installed on Pin
Figure 40 - Align One Half of Blade Alignment Tool
Figure 41 - Blade Alignment Tool Installed