SPX Waukesha Cherry-Burrell Votator II, Operation And Maintenance Manual

Page: 46 / 84

Maintenance Waukesha Cherry-Burrell
Page 46 95-03057 October 2005
Shaft Installation - Horizontal Unit
1. If opposite drive end head has been removed, make
sure O-ring (See Figure 26, Item A) is installed in
opposite drive end head.
2. Install drive end head (if necessary).
3. Install mechanical seal on drive end of shaft as shown
in Figure 27. See “Mechanical Seal Maintenance” on
page 52.
4. Install all scraper blades on mutator shaft.
NOTE:
Blades should be kept in the same position on
mutator shaft throughout life of blade. Make sure blades
are removed and reinstalled in the same location on the
shaft.
5. Place shaft in shaft removal skid.
6. Push shaft and shaft removal skid into tube as a unit.
This will ensure that tube will not be scored when
shaft is replaced.
7. Push spline of shaft partially into gear reducer. Shaft
may need to be rotated slightly for splines to seat in
gear reducer. See Figure 28.
8. Lift shaft slightly to remove shaft removal skid.
9. Make sure O-ring (See Figure 29, Item A) is installed
in drive end head.
10. Install opposite drive end head by reversing procedure
for removal of head.
11. Install shaft bearing in head.
12. Lift the shaft and head, place over the tube ring and
position bayonet closure. Close locking latch and
secure by tightening latch retainer nut.
Figure 26 - Opposite Drive End Head O-ring
Figure 27 - Mechanical Seal Installation
Figure 28 - Align Shaft Splines with Gear Reducer
Figure 29 - Drive End Head O-ring
Figure 30 - Install Head Shaft Bearing