9
RECIPES
Preprogrammed recipes can be accessed quickly from any screen by selecting the recipe section of the top bar.
The recipe settings sections contains four tabs. The drop down list near the top if the page allows you to select which
recipe you would like to view, edit, or apply as the current spray parameters. The 1750+ is capable of storing up to 20
user
-
created recipes.
3.6 HMI OPERATION—SET SPRAY PARAMETERS
1.
Set the system to manual mode. Disconnect the nozzles. Set all pressure regulators to 0. Turn on the main air
pressure and increase liquid pressure gradually to flush the system. Everything is now flushed except for the nozzles.
2.
Connect the nozzles and set the pressure regulators to the required pressure and then check if there are any
leakage.
3.
If the nozzle type isn
’
t set, go to the
Spray Nozzle Settings
section of this manual.
STARTING THE SYSTEM
1.
Verify the system status is in
“
Run
”
mode. (top bar, right corner)
2.
If not, press
“
run
”
button until the system is in
“
RUN
”
mode.
3.
Be sure a recipe is selected If you have purchased the optional software upgrade and the desired PWM setpoint is
set in the recipe (between 1% and 100%
depending on your application).
3.7 ACTIVATING RECIPES
A recipe is a pre
-
configured set of parameters that allows you to change to a different production batch quickly. These
parameters cover most of the timing and spray settings.
By default, your new 1750+ control panel has simple timing to operate your PulsaJet electric spray nozzles. As an
optional item, you can unlock the recipe function on your new 1750+ controller which allow you to setup and save
different ways to spray each batch.
If you purchase the recipes functionality at a later date, you will receive an unlock code that you can enter directly into
the 1750+. You access this by clicking on the settings icon/users, then click in the space shown below and it will ask for
the code. Enter the code and recipes will be unlocked.
A recipe can be loaded by selecting it from the dropdown menu and clicking
“
Apply
”
to transfer the settings to the
1750+. If you edit the currently selected recipe, you must press
“
Apply
”
again for the changes to be applied.
Enter recipe code in the box at the bottom of the screen.
