4. Clean and lubricate walk deck bushings. For lubrication of deck bushings, use red
lithium grease. Remove bushing lubricant that touches the walk belt or deck
surface.
Note that product maintenance requirements depend on usage and environment. This
schedule is based on average use. Some products may require maintenance more
often than is suggested here. Please call the SportsArt Service department at 1-866-
709-1750 if you have questions.
a. First, center the belt. (See d. below.) Operate the treadmill at 1.2~2.5 mph or 2~4
kpm.
b. Hold onto the handles. Press your feet against the walk belt. If the front roller keeps
moving but the walk belt stops rotating, the walk belt tension should be increased.
c.
d. Note: Turning rear roller screws clockwise extends the rear roller toward the back
of the unit, increasing walk belt tension. Turning rear roller screws counterclockwise
brings the rear roller closer toward the front of the unit, decreasing walk belt tension.
By adjusting one screw clockwise, that side of the roller extends toward the back of
the treadmill, forcing the walk belt toward the other side. Always check walk belt
centering after each adjustment. Avoid making the walk belt hit one side or another.
Use standard safety procedures when accessing electrical parts. For products with
power cords, turn off unit power. Allow capacitors to discharge by waiting five minutes
before disconnecting the power cord from the power socket. After waiting five minutes,
remove covers to access the drive board and other components. For products without
power cords, let the unit sit without use for five minutes before accessing drive boards
and other components.
General Notes on Maintenance
To check walk belt tension:
Caution:
To adjust the walk belt, turn roller screws clockwise
緣
urn at a time. Then retest
walk belt tension. To avoid premature wear on components, do not over tighten the
walk belt.
51
Summary of Contents for T652M
