- 22 -
STEP 3 : Selecting the program
Programs on the left (SPORT programs
) blink.
If you choose the
SPORT programs
, validate “
OK
“.
To choose
HEALTH programs
, press the
key and validate “
OK
“.
Scroll through the programs by pressing the
key. The screen first dis-
plays the 1st lower pictogram while displaying the corresponding program number at the top.
To go back, press the
key.
You have now chosen the muscle zone(s) to be stimulated, and the program.
STEP 4 : Choose the “Warm-up phase” and option
(only for programs PG02 to
PG07).
The
“
WARM
-
UP PHASE
”
pictogram blinks in the top right corner.
The screen proposes a warming-up phase before starting the active phase of the program.
To select it, press “
OK
, otherwise press the
key, and validate “
OK
(it disappears from the screen).
Then the
pictogram blinks.
To select
“
ALT
”
, press the
key, to select
“
SIM
”
, press the
key, then validate “
OK
“.
If no key is pressed, the
“
SIM
”
mode is imposed by default by the “
OK
“ key.
If you have selected the warm-up phase,
“
SIM
”
is displayed when starting the program, as the warm-up phase
is only in the simultaneous mode.
The screen is displayed :
the battery level, phase duration (countdown in minutes), timer pictogram, the
“
ALT
”
or
“
SIM
”
option and warm-up phase if you have selected them.
The pictogram for the program chosen is lit, the muscle zone(s) chosen blink alternately.
STEP 5 : • Launching the start - Adjusting intensity
Then, press the + buttons of the intensity keys matching the wires connected to your electrodes or your belt to
start the program.
If the battery is low, do not start the program.
The power level(s) are displayed at the bottom of the screen. The intensities vary during the session according
to the program’s content.
A long press on the “
C
“ key returns the power rapidly to 0.
• Program performance :
• Use of the “
C
“ (Clear) key:
During the program, press the “
C
“ key during a phase to set its time to zero. The next phase starts unless you
have reached the end of the program. In this case, this key allows returning to selecting the 1st muscle zone
(as at normal end of program).
• Disconnecting the electrodes during the program:
If an electrode is disconnected, the channel concerned is reset to
O0
and blinks for 30 sec, before returning
to a fixed
O0
.
During these 30 sec, the electrode(s) can be reconnected, and power restored to the level required.
STEP 6 : End of program - Stopping
At the end of the session, the screen proposes to start a new session by blinking the front muscles to select the
1st muscle zone. Restart the starting procedure if you wish to continue on another muscle zone.
Otherwise, press the
key to stop.
The unit switches to standby after 5 minutes idle.
