42
Setting Tread-Belt Tracking
A 6 mm Allen wrench is provided for this adjustment. Make tracking adjustments on the left side bolt. Set belt speed at 3
mph ( 5 kmph). Be aware that a small adjustment can make a dramatic difference which may not be apparent right away. If
the belt is too close to the left side, then turn the bolt only a 1/4 turn to the right (clockwise) and wait a few minutes for
the belt to adjust itself.
Continue to make 1/4 turns until the belt stabilizes in the center of the running deck. If the belt is too close to the right side,
turn the bolt counter-clockwise. The belt may require periodic tracking adjustment depending on use and walking/running
characteristics. Some users may affect tracking differently. Expect to make adjustments as required to center the tread-belt.
Adjustments will become less of a maintenance concern as the belt is used. Proper belt tracking is an owner responsibility
common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING / TENSION ADJUSTMENTS
IS NOT COVERED UNDER THE WARRANTY.
Belt/Deck Lubrication Procedure
These First, you want to clean between the belt and deck to remove any debris that may be trapped. Use a clean, non-
fraying rag, t-shirt, or light towel. Halfway between the end of the treadmill and motor cover, shove the garment under the
belt until you can grasp it on both sides. Drag the garment the length of the entire belt 1-2 times. Remove the garment.
Do not lubricate with anything other than Spirit Fitness approved lubricant. Your treadmill comes with one tube of “Lube”
and extra tubes can be ordered directly from Spirit Fitness or your authorized Spirit Fitness dealer. You may also use a Lube-
n-walk kit that can be purchased through both aforementioned sellers.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your treadmill. If the lubricant
dries out, the friction between the belt and deck rises and places undue stress on the drive motor, drive belt and electronic
motor control board, which could result in catastrophic failure of these expensive components. Failure to lubricate the deck
at regular intervals may void the warranty.
The belt & deck come pre-lubricated and subsequent lubrication should be performed every 90 hours of use or if you
