IM-P204-03
CH Issue 8
4
1.11 Permits to work
All work must be carried out or be supervised by a suitably competent person.
Installation and operating personnel should be trained in the correct use of the
product according to the Installation and Maintenance Instructions.
Where a formal 'permit to work' system is in force it must be complied with.
Where there is no such system, it is recommended that a responsible person should
know what work is going on and, where necessary, arrange to have an assistant
whose primary responsibility is safety. Post ‘warning notices’ if
necessary.
1.12 Handling
Manual handling of large and / or heavy products may present a risk of injury. Lifting,
pushing, pulling, carrying or supporting a load by bodily force can cause injury
particularly to the back. You are advised to assess the risks taking into account the
task, the individual, the load and the working environment and use the appropriate
handling method depending on the circumstances of the work being done.
1.13 Residual hazards
In normal use the external surface of the product may be very hot. If used at the
maximum permitted operating conditions the surface temperature of some products
may reach temperatures of 250 °C (482°F). Many products are not self-draining. Take
due care when dismantling or removing the product from an installation (refer to
'Maintenance instructions').
Self-acting valves may operate unexpectedly during normal service. The risk of
personal injury should be assessed for each installation. Where appropriate, suitable
guarding should be fitted.
1.14 Freezing
Provision must be made to protect products which are not selfdraining against frost
damage in environments where they may be exposed to temperatures below freezing
point.
1.15 Disposal
Unless otherwise stated in the Installation and Maintenance Instructions, this product
is recyclable and no ecological hazard is anticipated with its disposal providing due
care is taken.
1.16 Returning products
Customers and stockists are reminded that under EC Health, Safety and Environment
Law, when returning products to Spirax Sarco they must provide information on any
hazards and the precautions to be taken due to contamination residues or mechanical
damage which may present a health, safety or environmental risk. This information
must be provided in writing including Health and Safety data sheets relating to any
substances identified as hazardous or potentially hazardous.
Summary of Contents for DLV7
Page 40: ...IM P204 03 CH Issue 8 40...
