<screen-id></screen-id>
To set the screen id to “screen-1-1”, use:
<screen-id>screen-1-1</screen-id>
Instruct the device to reboot once all the settings have been applied successfully. If this is not set, then
the device will put itself automatically in "Installation mode". A manual reboot or the application of
another configuration, having the
<reboot/>
command within, is necessary for the parameters to be
applied.
This instruction can appear anywhere in the XML configuration string. It will only be executed once all
other commends have been executed and verified. In case of errors, the device will not reboot.
For instance, to force the device to reboot at the end of the installation, use:
<reboot/>
Controls the shutdown temperature of the HMP200. By default the HMP200 will shut down if its
external temperature is too high to prevent injuries on user touching the device. When setting the
shutdown temperature to maximum it could result in the case temperature exceeding 50 °C (120 °F).
Touching the device case at this temperature might result in injury.
If the command is used without any value the default shutdown (safe temperature) will be used. If set
to
70
, a maximum temperature of 70 °C will be used.
Note: Only available for HMP200.
For instance, to set the shutdown temperature to default settings, use:
<shutdown-temperature></shutdown-temperature>
To set the shutdown temperature to its maximum value, use:
<shutdown-temperature>70</shutdown-temperature>
Added in 3.0.0 firmware release.
Indicates whether the wizard configuration interface should be used or not. The possible values are:
yes and no.
Summary of Contents for HMP series
Page 1: ...www spinetix com ...
