Time at which the screen must be turned off. The format expected is HH:MM, where
HH is the time express in 24 hour format. If omitted the value of 24:00 will be used. A
value of 24:00 is equivalent to the value 00:00.
For instance, to clear a fixed scheduling previously set, use:
<display-power-schedule/>
To setting the fixed scheduling to turn on screen at 1 AM and switching it back off at 11 PM, use:
<display-power-schedule>
<on-time>01:00</on-time>
<off-time>23:00</off-time>
</display-power-schedule>
Indicates that the player can trust the information returned by the TV screen concerning underscan.
This information will be used only when connected to the screen using HDMI.
The possible values are: yes, no.
Note: Device must be rebooted for this parameter to be applied.
For instance, to enable the underscan video mode (if supported by the screen), use:
<underscan-supported>yes</underscan-supported>
Controls if the VGA connector is powered or not. If this is set to
auto
, the VGA will be powered only if
a screen connected to the HMP using a VGA cable provides some DDC feedback. If a VGA screen is
connected to the player but stays black, then this setting should be set to
on
.
The possible values are: auto, on, off.
For instance, to set the power mode for VGA to automatic detection of connected screen, use:
<vga-power-mode>auto</vga-power-mode>
Added in 2.2.4 firmware release.
Indicates that the VGA display connected to the player supports a DC voltage offset in the RGB signals.
This is normally supported by all VGA displays, but can be disabled in case of compatibility issue.
The possible values are: yes, no.
Summary of Contents for HMP series
Page 1: ...www spinetix com ...
