© 2014 Spicetone OÜ www.spicetone.com Võistluse 9, Tallinn 10132, Estonia, European Union
4 PRESETS
4.1 O
VERVIEW
OF
P
RESETS
By default, 24 PRESET MEMORY SLOTS (12 green, 12 red) are at your disposal. Choose the
presets either by rotary encoder (ENC) or the footswitches PREV and NEXT.
Each PRESET MEMORY SLOT (Preset 1…23) holds information of the corresponding FX ON
settings. Presumably these are you overdriven and/or modulated sounds.
Preset 24 is special. This is the memory slot dedicated to your bypassed, clean tone. In Player
Mode you can use FX/ESC footswitch to toggle between selected preset (Preset 1…23) and
Preset 24. You can also browse to Preset 24 with PREV or NEXT footswitch or by turning the
encoder.
In the context of your selected Preset Bank, Preset 24 is your global clean preset. Saving it means
you alter the clean tone that you get when you press FX footswitch OFF. Normally you wouldn’t
want to make it dirty, so turn on DRY and keep DRIVE and GAIN pots low.
There are two exceptions in displaying Preset in the Clock. When you are in Preset 12 (green at
12 o’clock) and switch FX off (activate Preset 24), the LED will go yellow, not red. And if you
browse to Preset 24 and press FX/ESC, then nothing happens, as you are already in Preset 24.
MIDI users, please keep in mind that for no drive effect situation (FX off), your MIDI controller
actually sends a message to activate Preset 24 (i.e preset change).
Note that by default the device starts up in first preset (Clock Position Green
1). You can make to
start up in the last preset used.
START WITH FIRST PRESET
Menu 10 Clock 4: On (
G
) / Off (
R
)
4.2 A
UTOMATIC
S
TORE
If you tune the POTS in a PRESET, the new settings are stored automatically, so that the next
time you return to this preset slot, you have the last used settings.
NB! Autostore is just for temporary setup. You have to save your favourites, because settings are
autostored only until the device is powered on. You lose all unsaved content if you switch it off
without saving.
There's a SAVE LED in the middle of the CLOCK, on the right. If you turn any pots or change
settings in menus, the LED light up red. This means the active Preset Memory Slot contains new
information that has not been saved yet. Please note that because of a technical limitation the
SAVE LED can be a bit too active in lighting up. This can happen when a pot is close to the saved
value and thus becomes active. To put it short, if you are very sure that you have saved your
preset, just ignore this LED if it shows the opposite.
