© 2014 Spicetone OÜ www.spicetone.com Võistluse 9, Tallinn 10132, Estonia, European Union
MIDIOut
Menu 10 Clock 2 : On (
G
) / Off (
R
)
You can choose if a MIDI signal coming to MidiIn on 6Appeal, is transferred on to MidiOut on
6Appeal. This is useful in advanced MIDI routing, as we do not have a dedicated MidiThru
connector on 6Appeal. Unless you’re an advanced user, keep MIDI THRU off.
MIDI THRU
Menu 10 Clock 3: On (
G
) / Off (
R
)
To set up correct MIDI control you have to set Midi In and Midi Out channels according to your
MIDI setup (Menu 9 items 10 and 11). By default both of these are set to channel 6. Please note
that 6Appeal can only be set to MIDI channels 1 to 12, even though MIDI standard channel range
is 1 to 16 – this is a limitation of our user interface, sorry for that. We also recommend you to
avoid MIDI channels 11 and 12 if you want to use 6Appeal in MIDI MonoMode.
MIDI IN CHANNEL SUBMENU
Menu 10 Clock 10
MIDI OUT CHANNEL SUBMENU
Menu 10 Clock 11
You may turn on MidiAll (Menu item 12), but be very careful with and use it just for very simple
setups. In this case 6Appeal reads and executes all MIDI commands and in complex MIDI setup
this may cause havoc.
MIDIALL (OMNI):
Menu 10 Clock 12: On (
G
) / Off (
R
)
To set up correct MIDI control you have to set Midi In and Midi Out channels according to your
MIDI setup (Menu 9 items 10 and 11). By default both of these are set to channel 6. Please refer
to 6Appeal’s extended MIDI CC and Note On control table in the annexes.
MIDI MonoMode is a special mode to control Envelopes for each string separately. Please refer
to Chapter
MIDI MONOMODE
Menu 10 Clock 4 On (
G
) / Off (
R
)
In Menu 9, POTs do the same as in Player Mode (i.e what is written next to them).
6.10M
ENU
10. G
LOBAL
P
ARAMETERS
Menu 10 (POT10 blinking) is for global parameters. First of all you can set the device to be used
only with monophonic guitars (1/4” Mono In). If the MONOGUITAR setting is on, then plugging
in a mono guitar with a TS cable automatically shuts off hexaphonic channels 1...6. If you want to
use a Mono In and 13pin input at the same time, you have to turn MONOGUITAR off.
MONOGUITAR
Menu 10 Clock 1 : On (
G
) / Off (
R
)
You can use the three 1/4” outputs as breakout box. These are stereo (two channel) outputs, so
two strings run through one output. If you want to separate the signals, use Y cables (TRS to
2xTS). Also, when BREAKOUT BOX is engaged, Mono In turns into Mono signal output, so you
can even get the monophonic signal out from your hex guitar.
BREAKOUT BOX
Menu 10 Clock 2: On (
G
) / Off (
R
)
