© 2014 Spicetone OÜ www.spicetone.com Võistluse 9, Tallinn 10132, Estonia, European Union
SAVE LED shows my preset is not saved, even though I did save it? We are sorry! Because of a
technical limitation the SAVE LED can be a bit too active in lighting up. This can happen when a
pot is close to the saved value and thus becomes active. To put it short, if you are very sure that
you have saved your preset, just ignore this LED if it shows the opposite.
You have connected guitar’s monophonic output to 6Appeal, using 1/4” TS cable, but you hear
no sound. Turn up MONO POT to hear your monophonic channel. Normally it is turned down, to
avoid intermodulation distortion.
You have connected guitar’s monophonic output to 6Appeal, using 1/4” TS cable, but you hear
no sound. Disconnect 13pin cable and check if MONOGUITAR feature is turned on. Turn it on.
MONOGUITAR
Menu 10 Clock 1 : On (
G
) / Off (
R
)
You also have to switch off G-VOL feature in Menu 10 (“Global”), otherwise it may happen that
neither hex nor mono sound comes through.
G_VOL GK VOLUME KNOB
Menu 10 Clock 6: On (
G
) / Off (
R
)
I cannot get the modulations (LFO1, LFO2) going! Checklist:
o
Is LFO on? (Menu 4 or 5, Clock Position 11)
o
Is LFO controlled by MIDI? You must have an external MIDI device working,
otherwise switch this feature off (Menu 4 or 5, Clock Position 9 to Dark).
o
You must have at least one modulation type set (Menu 4 or 5, Clock Position 7 or
8).
o
You must turn at least one of the Pots 1…6, thus defining modulation depth for at
least one parameter.
o
In Menu 4 or 5, Pot 9 that controls modulation amplitude, must not be in zero
position.
I cannot get SEQUENCER going! Checklist:
o
Is SEQ on? (Menu 3, Clock Position 11)
o
You must define a sequence type in Menu 3 Submenus, available in Clock
positions 7 and 8
o
SEQ does not start with preset; set it to start with preset (Menu 3 Clock Position
9 Green)
o
You must turn at least one of the Pots 1…6, thus defining sequenced modulation
depth for at least one parameter.
o
In Menu 3, Pot 9 that controls modulation amplitude, must not be in zero
position.
15.2P
ROBLEM
R
EPORTING
In case of problems with your device please contact the retailer.
If the retailer is not available and the sales guarantee does not apply any more, please send an
email to
, containing:
* Your name, contact address, country/state
* Name and product code of the device