Sperry Marine VISIONMASTER FT ECDIS-E, User Manual

Page: 386 / 425

Conning Information Display ECDIS-E User Guide
12-2 65934012
Docking Display
The docking display uses various sensor data from serial interfaces
connected to a PCIO unit to compute own ship’s fore and aft motion and its
port and starboard velocity at the bow and the stern.
The docking display is intended for use during ship docking and other low-
speed manoeuvring operations such as anchoring.
To access the docking display window click on
the
CID button on the lower popup toolbar and
select Docking. The Docking Display popup
window appears on the chart display.
The docking display shows the following data:

True heading data, the current bearing
value as shown in the HDG data display
(see Sensor Data Display) and the data
source of the value e.g. Gyro.
A graphical display below the HDG also
shows the bearing value.

True course over ground (COG), the
current bearing value as shown in the
COG data display (see Sensor Data
Display) and the data source of the value
e.g. GPS.

Rate of Turn (ROT), the current rate of turn in degrees per minute
as shown in the ROT folder, (see Rate of Turn Values).
A graphical display below the ROT also shows the degrees per
minute value.

Speed over Ground (SOG) data displaying the following values (in
kilometres) and source of data:

Bow Port/Starboard speed over ground

Ship Port/Starboard speed over ground

Ship Fore/Aft speed over ground

Stern Port/Starboard speed over ground