27 |
S p e d o 2 6 0 0 O p e r a t o r M a n u a l
S p e d o U K L t d
27
Spedo 2600 Pinless Cutter Operator Manual
Paper Loading
Select required job from the JOB LIST page.
Check the form length; if necessary adjust the form depth and strip depth
using the on-screen digital coding keypad displayed on the touch panel.
Switch on the MAINS switch. Check that the MAINS switch and the STOP
switch have illuminated.
Open the protective cover. Release the centre cutter away from the paper
path.
Open the in-feed tension brush and feed the paper web underneath it over
the in-feed plate. Return the in-feed tension brush to its operating position.
Pull enough length of paper web through so that it can lie unsupported on
top of the paper supports.
Set the space between the paper guide units at approximately the required
distance and position the paper clamps and paper supports at equal
intervals between the guide units.
Open the paper guide unit flaps and pull enough length of paper through so
that it now covers the main drive roller. Lower the pressure roller and adjust
the pressure if necessary.
Close the paper guide unit flaps and check that the space under the flaps is
enough to cater for the weight (thickness) of paper web. If necessary, adjust
the height of the RED adjusters until the flaps are at the required setting.
With the flaps closed, adjust the space between guide units so that the
paper lies flat and is slightly tensioned across its width.
Close the protective cover. Press the START pushbutton to extinguish the
STOP pushbutton. Use the Line Advance pushbutton to align the leading
edge of the paper web with the end of the paper guide unit flaps.
If side trimming is required, open the protective cover and slide the side
trimmer(s) so that the trimmer block(s) engage with the guide unit(s),
(position 3 as shown on Fig 3.9). Align the yellow cut mark with the side
carrier cut line.
If a centre cut is required, engage the centre cutter and adjust its position to
align with the centre cut mark on the paper web, as shown in Fig 3.8. Close
the protective cover. Press the START pushbutton to extinguish the STOP
pushbutton.
Set the batch counter as required. A pause facility has been incorporated to
allow automatic batching of form sets without the need for operator
intervention.
The cutter is now ready to be operated. However, before starting, ensure
that a paper loop has formed between the in-feeding ancillary unit (if
present) and the guillotine and that the loop will be automatically controlled
by the system.
Having set the guillotine as required above, proceed as follows:
