Chapter 3
Using the Function Menu
3–4
The C-Port option on the Function Menu lets you manually adjust the
communication port parameters. Normally these parameters are set from the
DPS programming software when an application is downloaded.
Select C-Port [1] from the Function Menu.
1 C-Port
5 Special
2 P-Port
6 Term
3 Clk/Cal
7 Test
4 Reset
8 Other
This menu displays:
Select Item:
1 Baud Rate
4 Exit
2 Data Bits
3 Parity
Exits to Function Menu
Select an item by pressing the corresponding numeric key [1]
!
[4].
Baud Rate
Selecting Baud Rate [1] displays the current baud rate.
Select Baud Rate:
Baud Rate
2400
”NEXT” To Change
”ENTER” To Select
Press [NEXT] to toggle through the options: 300, 1200, 2400, 4800, 9600,
19200, 38400. Press [
] to select a new rate. DH-485 communications
with an SLC or network cannot be set to 300 Baud.
Data Bits
Selecting Data Bits [2] displays the current setting.
Select Bit Counts:
Bits
8
”NEXT” To Change
”ENTER” To Select
Press [NEXT] to change between 7 or 8 bits. Press [
] to select a setting.
Parity
Selecting Parity [3] displays the current setting.
Select Parity:
Parity
None
”NEXT” To Change
”ENTER” To Select
Press [NEXT] to change between Even, Odd, or No parity. Press [
] to
select a new parity.
Setting Communication
Port Parameters
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
