Chapter 3
Using the Function Menu
3–2
Many DTAM Plus functions are accessed from the Function menu. To
access the Function menu, press the [F] key on the keypad. All other
functions are halted when the menu is displayed.
Note: To enable the F (Function) key, DIP switch SW-4 must be set ON.
The Function menu provides access to these functions:
1 C-Port
5 Special
2 P-Port
6 Term
3 Clk/Cal
7 Test
4 Reset
8 Other
Select a menu item by pressing the corresponding numeric key [1]
!
[8].
The menu structure is shown below:
Resets the DTAM Plus
Configures the Comm Port
Special Controller Operations
1 C-Port
5 Special
2 P-Port
6 Term
3 Clk/Cal
7 Test
4 Reset
8 Other
Select Item:
1 Baud Rate
4 Exit
2 Data Bits
3 Parity
1 Baud Rate
5 L/Feed
2 Data Bits
6 Penable
3 Parity
7 Exit
4 Hndshk
Configures the Printer Port
Sets the Clock /Calendar
1 Half Duplex
2 Line Feed Enable
3 Cursor Enable
4 Exit
Configures Terminal Mode
Screen display depends
upon operating system.
Refer to Appendix C.
1 Simulate 5 Master C
2 BL / INT 6 Scale E
3 Contrast 7 Exit
4 Prn Scrn
DTAM Plus Diagnostic
NEXT to Select Test
ENTER to Initiate
[Test Function]
Performs Self Tests
Accesses Additional Functions
Function Key Menu
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
