SpectraLink Link 150, Installation And Operation Manual

Page: 23 / 89

SpectraLink Link 150 Installation and Operation
12/28/98 15
5. Install SpectraLink System
5.1 Survey Site
Check the site to be sure pre-installation work has been completed correctly. This
includes:
1. Location chosen for the MCU is adequate, and power is available. Multiple MCUs
must be installed side by side, not stacked on one another.
2. Wiring to Base Station locations has been pulled and correctly terminated.
3. Phone lines for the wireless telephones are installed and properly terminated.
4. Dedicated line is available for remote access to diagnostic modem.
5. Telephone system administrator is on-site to program the existing telephone
system.
If the work has not been completed, you can leave the site and reschedule the installation
when the items have been completed or corrected, or assist in preparing the site.
5.2 Check Components
The following items should be at the installation site.
LINES
CELLS
REGISTER REGISTER
STEP
ADMIN ADMIN
NORM NORM OFF OFF
ON ON
ALARM ALARM
ERROR ERROR
DELETE
1
2
3
4
5 6
7
8
9 10
11 12
13 14
15 16
1
2
3 4
Link 150 Master Control Unit – Depending on the size of
your system, there may be up to four MCUs, which will be
chained together to extend the coverage area.
AC Adapter – Supplies power to the Link 150.
Use only the provided Class II AC Adapter
with output 24VDC, 1A.
IPC Cable – Each MCU is shipped with one Inter-
Processor Communication (IPC) cable to carry signals
between Link 150 units. This 8-pin modular connector is
keyed so that it will not plug into the Base Station ports. It
is used only when multiple MCUs are chained together.