8
3
Installation Information
Preparation Guide
1. Upon receipt of the pump, check the carton for damage. Open the carton and check the pump for
concealed damage, such as cracks, dents, or a bent base. If damage is found, contact the shipper or
distributor where the pump was purchased.
2. Inspect the contents of the carton and verify that all parts are included.
See Section 7, Parts List and
Exploded View.
NOTE: In Canada, the pump must be located a minimum of three (3) meters (approximately ten
(10) feet) from the water (CSA C22.1).
1. Speck Pumps recommends to achieve better self-priming, install the pump as close to the pool as
practical. Consult local codes for minimum distance between pool and pump.
WARNING: Some Safety Vacuum Release System (SVRS) devices are not compatible with
the installation of check valves. If the pool has an SVRS device, be sure to confirm that it will
continue to safely operate when the check valves are installed.
2. The piping should be as direct and free from turns or bends as possible, as elbows and others fittings
greatly increase friction losses.
3. Place pump on solid foundation which provides a rigid and vibration-free support so that it is readily
accessible for service and maintenance.
4. Protect the pump against flooding and excess moisture, and event foreign objects from clogging
air circulation around motor. All motors generate heat that must be removed by providing proper
ventilation.
5.
DO NOT
store or use gasoline or other flammable vapors or liquids in the vicinity of this pump.
DO
NOT
store pool chemicals near the pump.
6.
DO NOT
remove any safety alert labels such as
DANGER, WARNING,
or
CAUTION
. Keep safety
labels in good condition and replace any missing or damaged labels.
7. Provide access for future services by leaving a clear area around the pump. Allow plenty of space
above the pump to remove lid and basket for cleaning.
Pump Location
