Specac Atlas GS15800, User Manual, Page: 15 / 48

Atlas™ High Temperature Film Maker Accessory
13
Fig 3. Water In and Water Out Connections for High Temperature
Film Maker Accessory
Preparing the Press and Film Maker for Use
The following explanation is for installation of the Atlas™ High
Temperature Film Maker Accessory into an Atlas™ Manual 15T or 25T
Hydraulic Press. However a similar installation procedure can be
adopted if using an Atlas™ Power 8T or Autotouch 8T Press.
Ideally, any Specac Press to use will be situated close to a clean, cold
water supply and a drainage facility for provision of cooling water to the
High Temperature Film Maker Accessory in operation. If this is not
possible to accommodate, even by using additional lengths of water
cooling tubing, then use of a remote and portably sited water thermo-
circulating system may be suitable to facilitate for water cooling.
For use of the High Temperature Film Maker Accessory in
any
compatible Specac Press , the top bolster pressing face ( 8 ) MUST be
fitted into the lead screw ( 9 ) of the Press. (See Fig 4 .)
2
3
7
6
6
7
Water OUT
Water IN