Spearhead Swipe
E
150/
E
180/
E
210
22
22
22
22
•
Check that all blades are in place and that they are in good condition.
•
Smear all unpainted metal parts with grease and lubricate all grease nipples.
•
Make a note of any item that needs replacing so that parts can be ordered.
Disposal
Disposal
Disposal
Disposal
At the end of the machines working life all the parts that may cause danger
have to be made inert. The materials forming the machine have to undergo a
differentiated division, these materials are:
▲
Steel (Deck, ‘A’ Frame, Blades etc.)
▲
Mineral Oil (within Gearbox)
▲
Rubber (Rear Guarding)
▲
Plastic (PTO Guarding)
All the above mentioned operations and the disposal have to be carried out in
total respect of the present provisions of law on the subject.
TROUBLESHOOTING
Troubleshooting Chart
Troubleshooting Chart
Troubleshooting Chart
Troubleshooting Chart
PP
Problem
PP
Suggested cause
R
Remedy
e
Irregular Cut
Worn, bent or broken blades.
Machine is not level with the ground.
Material blockage due to speed.
Replace item(s).
Level the machine.
Reduce working speed.
Machine Noise
Loose bolts.
Cracks or initiation of cracks in deck.
Tighten Bolts.
Have it repaired in
specialised workshop.
Gearbox noise
Lack of oil.
Worn bearings.
Worn gears.
Fill to level.
Replace.
Replace.
Vibration
Broken or worn blades.
Unbalanced rotor.
Replace.
Replace in authorised
workshop.
Premature blade
wear
Blades contacting the ground.
Adjust the height of cut.
Excessive
backlash in joints
Worn pins
Replace
Problem Suggested Cause Remedy
