b
18
4.4.4 Operation of the ratchet
IV
V
Lashing device basic position/ starting position
a
1. Open ratchet lever
7
.
2. Place the empty slotted shaft
5
in the threading position for the
loose end
1
.
Applying the lashing
3. Place the lashing on the load.
4. Hang fasteners securely in the lashing points.
Length adjustment of the lashing
b
5. Thread the loose end
1
into the opening
5
of the slotted shaft
2
and pull it through until the strap lies against the load.
Clamping the lashing device
c
6. Tighten (move the ratchet lever back and forth) until the desired
tension is achieved.
– There must be at least 1.5 windings, but no more than 3,
on the slotted shaft
2
.
– Tighten diagonal lashings hand-tight.
Secure clamping element
d
7. After lashing, pull the function slider
6
.
8. Turn the ratchet lever
7
so far in the closed position until the
slide
4
can engage in the safety recess.
– The ratchet is now closed.
Loosen
e
9. Pull the function slider.
6
10. Swivel the ratchet lever
7
through 180° to the end stop to
lock the slider in the last possible recess.
ATTENTION!
All the
tension in the lashing is released at the same time!