60
ERROR MESSAGES
Error:
SynthFile name is too long.
The full waveset file path and name (combined) in SNDSCAPE.INI
must be no more than 63 characters long. You can try downloading
and installing the latest AudioPCI™ drivers, specifying a shorter
Destination Path for the MS-DOS Utilities. Then, select or add a
different waveset file with a shorter filename.
Error:
Cannot open <path>\AUDIOPCI.BIN.
This will occur if the AUDIOPCI.BIN file could not be found.
It should reside in the same directory as APINIT.COM,
APCONFIG.EXE, and APLOAD.EXE. Download and install the
latest AudioPCI™ drivers.
Error:
AudioPCI™ hardware has not been configured by PCI BIOS.
This may occur if you specify “Use plug and play OS” in your BIOS
setup and enter MS-DOS Mode before Windows 95 loads. Try us-
ing the BIOS setup utility to configure PCI devices or shutdown to
MS-DOS Mode from Windows 95.
Error:
AudioPCI™ hardware was not detected.
This will occur if the AudioPCI™ hardware is not installed cor-
rectly. Try reinstalling the hardware.
Error:
Cannot open <path>\<*.ECW>.
This will occur if the waveset *.ECW file, pointed to by the
SNDSCAPE.INI file, cannot be found. Select or add a different
*.ECW file.
Error:
Waveset sample rate is not 22050 Hz.
Select or add a different *.ECW file.
Error:
Current chip revision is out of date.
This message will appear if production software is used with a pre-
production chip.
Error:
BLASTER environment variable missing or incorrect.
This message will occur if the BLASTER environment variable was
not properly set. Make sure the “Enable Legacy Emulation” box is
checked on the Settings tab of the AudioPCI™ Device Properties
window.