12
When cranking test is abnormal, battery test result will
also be displayed at the same time.
This is for the convenience of the maintenance
personnel to quickly know the whole state of the
starting system according to the data.
After you have finished testing, do not shut down the
engine, press ENTER key to enter Charging Test.
CHARGING SYSTEM AND RECTIFIER DIODE TEST
When doing the charging test, please choose "Charging
Test".
Press ENTER key again to start the charging test.
NOTE: Do not shut down the engine during the test.
All electrical appliance and device are in OFF.
Turn off any electrical appliances in the vehicle during the
test as it will affect the accuracy of the test result.
TESTER WILL DO THE FOLLOWING TESTS IN SEQUENCE:
RIPPLE TEST
For ripple test, tester will display the real time ripple and
meanwhile, shows ripple volt and charging volt values at
the bottom line.
It takes approx. 6 seconds for the ripple test.
CHARGING TEST
After the ripple test, tester will automatically start the
loaded voltage test.
Loaded Volt Test takes approx. 3 seconds, then it hints
"Step on accelerator to increase engine rotation speed"
Operate accordingly to increase the engine rotating speed
to 2500rpm or above, and keep for 5 seconds.
Tester starts the charging volt test after it has detected a
increase in rpm.
Time 1020ms
Cranking Low
10.13V
Cranking Test
1.
Battery Test
2. Cranking Test
3. Charging Test
Test In-Vehicle
95mV 14.32V
Ripple Test
Loaded Testing ****
Charging Test
Increasing RPM to
2500 r/min
And keep it 5
seconds.
Press OK to
continue.
Charging Test
