112
4. Select the intended RAID level in the popup selection box
and press
Enter
.
5. Select
2. Select Disk Drives
in the menu and press
Enter
.
6. Select the harddisks to be used for creating the disk array
and press
Enter
to confirm.
7. Select
3. Start Creation Process
.
8. Pay attention to the warning message, and press
Y
to finish
creation.
Note:
1. If you have selected
Striping (RAID 0) for Performance
in
the popup sub-interface after the operation of
1. Array Mode
,
you should directly go to
3. Strip Size 64K
and then select
4.
Start Creation Process
. The default strip size is
64K
.
2. If user is creating RAID 0+1, then user must select four single
disks. All data on these disks will be destroyed after creation
of RAID 0+1.
3. Different warning messages appear according to different
RAID levels.
II. Delete RAID
The following steps shall be taken to delete RAID.
1.
In the menu zone, select
2. Delete RAID
, press
Enter
to
confirm this operation and go to next.
2.
In the validated channel status, use the arrow key to select
the disk array to be deleted and press
Enter
to confirm.
3.
Press
Y
when warned
Are you sure you want to remove
the disk array?
III. Rebuild Mirror Array
The following steps shall be taken to rebuild the mirror array.
1.
In the menu, select
3. Rebuild Mirror Array
, press
Enter
to
confirm.
2.
In the menu, select
1. Select Source Disk: None
and press
