-48-
For Machines Mfd. Since 3/21
South Bend Tools
Model SB1119/SB1120
M A I N T E N A N C E
Machine Storage
All machinery will develop serious rust problems
and corrosion damage if it is not properly
prepared for storage. If decommissioning this
machine, use the steps in this section to ensure
that it remains in good condition.
To store machine:
1.
Disconnect all power sources to machine.
2.
Thoroughly clean all unpainted, bare metal
surfaces, then coat them with light weight
grease or rust preventative. Take care to
ensure surfaces are completely covered but
that grease or rust preventative is kept off of
painted surfaces.
Note:
If machine will be out of service for
only short period of time, use way oil or good
grade of medium-weight machine oil (not
auto engine oil) in place of grease or rust
preventative.
3.
Loosen or remove V-belt so it does not
become stretched while machine is not in
use.
4.
Completely cover machine with tarp or
plastic sheet that will keep out dust and
resist liquid or moisture. If machine will be
stored in/near direct sunlight, use cover that
will block sun's rays.
Lubrication
Since all bearings on the Model SB1119/SB1120
are sealed and permanently lubricated, simply
leave them until they need to be replaced. DO
NOT lubricate them.
Below is a list of components that require
periodic lubrication. Do not over-lubricate these
components. Large amounts of lubricant will
attract sawdust, causing the metal components
to gum up and bind.
T26419—Syn-O-Gen Synthetic Grease
Formulated with 100% pure synthesized
hydrocarbon basestocks that are compounded
with special thickeners and additives to
make Syn-O-Gen non-melt, tacky, and water-
resistant. Extremely low pour point, extremely
high temperature oxidation, and thermal
stability produce a grease that is unmatched in
performance.
Figure
Figure 76. Model T26419 Syn-O-Gen Synthetic
. Model T26419 Syn-O-Gen Synthetic
Grease (NLGI#2 equivalent).
Grease (NLGI#2 equivalent).