South Bend Tools SB1119, Owner'S Manual, Page: 22 / 76

-20-
For Machines Mfd. Since 3/21
South Bend Tools
Model SB1119/SB1120
P R E P A R A T I O N
Drawbar Drawbar
Spindle Base Spindle Base
Assembly Assembly
10-15 Turns 10-15 Turns
Figure Figure 20. Drawbar inserted into bottom of spindle . Drawbar inserted into bottom of spindle
base assembly. base assembly.
Make sure spindle and drawbar are aligned
and properly seated before tightening drawbar
nut. Improper assembly can create an unsafe
condition and possible injury to operator and
bystanders.
Figure Figure 18. Location of spindle lock components. . Location of spindle lock components.
Spindle Assembly Spindle Assembly
Lock Handle Lock Handle
V-Belt V-Belt
2. Lay straightedge across outer insert and
table surface in pattern shown in Figure 17.
Straightedge
Table Insert
Table Surface
+
+
+
Flat Head
Screws (1 of 3)
Figure Figure 17. Straightedge and surface pattern. . Straightedge and surface pattern.
3. Adjust flat head screws so ends of
straightedge lay flat on table surface at all
positions of pattern above.
IMPORTANT: Table insert and surface must
be aligned evenly to ensure workpiece does
not catch on table insert or surface and kick
back.
4. Open cabinet door.
5. Unlock spindle seat by pulling spindle
assembly lock handle and turning
1
/
4
turn
(see Figure 18). Turn V-belt and pulleys
until you hear a click.
Figure Figure 19. Inserting spindle into place. . Inserting spindle into place.
Spindle
Cartridge
Spindle
Base
6. Insert spindle base into spindle cartridge
(see Figure 19). Thread spindle nut onto
cartridge approximately 1 turn.
7. Insert drawbar into bottom of spindle base
assembly, up through spingle pulley and
assembled parts, and rotate approximately
10-15 turns (see Figure 20).