South Bend Tools
For Machines Mfd. Since 3/21
Model SB1119/SB1120
-21-
P R E P A R A T I O N
8.
Secure spindle nut with spindle wrench and
tighten drawbar nut (see Figure 21). DO
NOT use excessive force.
Figure
Figure 21. Tightening drawbar nut (guard/fence
. Tightening drawbar nut (guard/fence
assembly removed for clarity).
assembly removed for clarity).
9.
Lock spindle seat by returning spindle
assembly lock handle to original position.
Spindle should rotate freely in both
directions.
10.
Using precision level, adjust machine feet
until table is level (see Figure 22).
Figure 22. Location of machine feet.
Figure 22. Location of machine feet.
Machine Foot
Machine Foot
(1 of 4)
(1 of 4)
Dust Collection
This machine creates a lot of wood chips/
dust during operation. Breathing airborne dust
on a regular basis can result in permanent
respiratory illness. Reduce your risk by
wearing a respirator and capturing the dust
with a dust-collection system.
Recommended CFM: 400 CFM at Each Port
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust
collector, (2) hose type and length between the
dust collector and the machine, (3) number of
branches or wyes, and (4) amount of other open
lines throughout the system. Explaining how to
calculate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect dust collection system to
machine:
1.
Fit 4" dust hose connected to dust collector
over each dust port and secure each in place
with hose clamp (see Figure 23).
2.
Tug hoses to make sure they do not come off.
Note:
A tight fit is necessary and ensures
proper performance during operation.
Figure
Figure 23. Example of dust hoses attached to ports.
. Example of dust hoses attached to ports.