-34-
For Machines Mfd. Since 3/21
South Bend Tools
Model SB1119/SB1120
O P E R A T I O N
1.
Follow Steps 1
–
5 of Removing Material
from Entire Board Face on Page 33.
2.
Loosen fence lock knobs to move fence faces
so they barely clear cutter on each side (see
Figure 50). This allows maximum support
possible for workpiece when passing cutter.
Removing Material from Part of
Board Face
Figure
Figure 50. Fence clearance controls.
. Fence clearance controls.
Fence
Fence
Lock Knob
Lock Knob
(1 of 2)
(1 of 2)
3.
Tighten lock knobs when fence faces will best
support workpiece.
4.
Adjust outfeed fence face to same plane as
infeed face.
5.
Turn shaper ON.
6.
Run a test piece through shaper (see
Figure 51).
End View
Direction of Feed
Outfeed
Fence
Infeed
Fence
Figure
Figure 51. Partial feed fence adjustment.
. Partial feed fence adjustment.
7.
Turn machine OFF.
End View
Direction of Feed
Outfeed
Fence
Supported
Infeed
Fence
Figure
Figure 49. Support workpiece as it is fed through cut.
. Support workpiece as it is fed through cut.
9.
When cutter comes to complete stop, adjust
outfeed fence using technique used in
Steps 2
–
4 to support new profiled edge (see
Figure 49).