-22-
For Machines Mfd. Since 3/21
South Bend Tools
Model SB1119/SB1120
P R E P A R A T I O N
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note:
Refer to Troubleshooting on Page 59 for
solutions to common problems that may occur.
If you need additional help, contact our Tech
Support at (360) 734-1540.
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine may
result in malfunction or unexpected results
that can lead to serious injury, death, or
machine/property damage.
The test run consists of verifying the following:
• Motor powers up and runs correctly.
• Spindle rotates in correct direction (SB1120
only).
• STOP button disables the machine properly.
To test run machine:
1.
Clear
away all tools and objects used during
preparation and assembly.
2.
Press STOP button (see Figure 24).
3.
Turn RPM adjustment knob all the way
counterclockwise (see Figure 24).
Figure
Figure 24. Control panel controls.
. Control panel controls.
5.
Connect machine to power.
6
. Twist STOP button clockwise until it springs
out (see Figure 25). This resets the switch
so machine can start.
Figure
Figure 25. Resetting the switch.
. Resetting the switch.
7.
Press ON button to turn machine ON (see
Figure 24).
8.
Turn FOR/REV switch to FOR position (see
Figure 24). Verify motor starts up and runs
smoothly without any unusual problems or
noises.
— For SB1119: Proceed to Step 14.
STOP Button
STOP Button
FOR/REV Switch
FOR/REV Switch
ON Button
ON Button
RPM Adjustment Knob
RPM Adjustment Knob
4.
Turn FOR/REV switch to OFF position (see
Figure 24).