ST2515 Operation Manual
27
3)
Touch GPIB to select the GPIB interface.
NOTE: This mode is available only when the optional GPIB interface is bought and installed.
4)
Touch LAN to select the LAN interface. ST2515 will not react to LAN unless selected here.
5)
Touch USBTMC to select the USBTMC interface. The instrument communicates with PC
through the USB interface on the rear panel.
6)
Touch USBVCOM to select the USBVCOM interface. The instrument communicates with PC
through the USB interface on the rear panel.
4.1.5
Baud Rate
Touch this key, the following six baud rates are selectable:
9600
19200
28800
38400
96000
115200
4.1.6
Bus Addr
Touch this key to control and display the current GPIB interface bus address.
Operation Procedures:
Touch Bus Addr, the following items will be displayed in the soft key zone.
↑↑ (+ +)
Touch this key, the instrument increases the number of bus address by 5.
↑ (+)
Touch this key, the instrument increases the number of bus address by 1.
↓ (-)
Touch this key, the instrument decreases the number of bus address by 1.
↓↓ (- -)
Touch this key, this instrument decreases the number of bus address by 5.
The bus address number ranges from 0 to 31.
4.1.7
EOC Signal
EOC (End-of-Measurement): Signal of measurement end with two setting modes for signal level:
HOLD and Impulse Input. The time of EOC level conversion varies with measurement time and
trigger mode.
Timing diagram of external trigger:
