The start address board 3000P makes use of decimal switches to set the address, and of DIP-Swit-
sches to set personalty and HOLD mode.
Address seting is straightforward:
S3:
Hundreds
S2:
Tens
S1:
Ones
IMPORTANT NOTICE:
It may take some se-
conds to check and verify the received switch
data. As soon as the new setting has been ac-
cepted and saved to memory, both LEDs (red
and green) blink alternatively four times.
IMPORTANT NOTICE:
The decoder can be
operated with or without start address board
connected. Please note that all switches beco-
me
disengaged
and the respective settings are overridden when programming of DMX start add-
ress, DMX personality or HOLD mode is done via RDM.
To re-engage the switches, set the hundreds position to „9“ temporarily (any address from 900 to
999 will do) and wait for a programming cycle to complete. A programming cycle is indicated by the
red and the green LED blinking four times alternatively.
DIP Switch Settings
The address board DIP Switches c an be used to tset the DMX Personality and DMX
Hold mode.
S1:
HOLD MODE
Sets the behaviour at DMX signal lossl
S1=OFF
HOLD Mode OFF
S1=ON
HOLD Mode ON: „Keep Last Look“
S2:
SAFETY LEVEL
Determines the relay state at loss off signal.
When the HOLD Mode (S1) has not been activated, these settings apply:
S2=OFF
all relays are set to OFF
S2=ON
all relays are set to ON
S3, S4: DMX Personality
Bestimmt die Schaltfunktion des Relaismoduls
Switch setting .
DMX Personality .
S3=OFF
S4=OFF
Personality 1
12 individual relays (12 addresses)
S3=OFF
S4=ON
Personality 2
2x 6 individual relays (6 addresses)
Use DMX RDM to invert the second block. This can be used to close relay
contacts in block 1, while those of block 2 will open simulktaneously.e Inver-
tierung für den 2. Block kann über DMX RDM gesetzt werden.