Special RDM Functions:
RESET_DEVICE:
calling with parameter =1 results in „warm reset“
calling with parameter = 255 results in „cold reset“
DEVICE_POWER_CYCLES:
reads device startups
DEVICE_HOURS:
reads device hours (non-resettable)
DMX HOLD MODE:
set DMX HOLD mode
(Param= 0...2, see below)
IMPORTANT NOTICE:
The decoder can be operated with or without start address board connec-
ted. Please note that all switches become
disengaged
and the respective settings are overridden
when programming of DMX start address, DMX personality or HOLD mode is done via RDM.
To re-engage the switches, set the hundreds position to „9“ temporarily (any address from 900 to
999 will do) and wait for a programming cycle to complete. A programming cycle is indicated by the
red and the green LED blinking four times alternatively.
Selecting the DMX Personality via RDM
(Screenshot from JESE Get/Set Software
)
The 3212R-H consists of a integrated sensor for power sup-
ply monitoring.
(Screenshot from JESE Get/Set Software
)
More RDM Functions
Please check our RDM-Website
(http://www.rdm.soundlight.de)
for more information, or down-
laod the RDM Manual from our Manuals Site
http://www.manuals.soundlight.de