Service Record Loop
SORG
RS
21 of 40
2019-07-16
3.3
Assembly Group Seat
(A)
(1)
(A)
(A)
(C)
(B)
(D)
(D)
(3)
(2)
(5)
(A)
(C) (D) (B)
(B)
(A)
(A)
(C)
(C)
(6)
(4)
(A)
(B)
(C)
(B)
Step 1: Control lever
• (1)
Remove the two screws
(A)
of the
control lever and the spiral cable sheath
from the Bowden cables.
Step 2: Move the gas spring
• (2)
Use the screws
(A)
to remove the
upper receptacle of the gas spring.
• (3)
Remove the two screws
(A)
.
• Move the holder
(B)
incl. Gas spring
(C)
into the alternative holes
(D)
.
• (4)
Move the upper bracket
(A)
into the
alternative holes
(B)
.
• (5)
Remove the inner cable of the Bow-
den cable
(A)
from the trigger mecha-
nism of the gas spring by loosening the
nipple
(B)
and adjusting screw
(C)
and /
or locknut
(D)
and pulling out the com-
plete Bowden cable
(A)
.
Step 3: Remove frame half
• Remove a frame half
Step 4: Insert new lower shots
• (6)
"Thread" the second lower seat
(A)
of the gas spring over the two trusses
(B)
and
• screw the mount with the screws
(C)
firmly into the prepared holes in the
trusses
(3D)
.
Step 5: Assemble the frame
• Screw the frame together (as already
described) on the trusses.
• Pay attention to the symmetry of the
crosshead adapters (right and left side
in the same hole!).
Step 6: Mount upper shots
• (1)
Screw the second upper receptac-
le
(A)
of the gas spring with the two
screws
(B)
under the seat plate into the
prepared holes.
Step 7: Mount new gas spring on top
• (1)
Screw the gas spring with the screw
(C)
to the upper receptacle
(A)
.
Step 8: Fit new gas spring down
• (2)
Screw the gas spring into the lower
holes with the screw
(A)
into the prepa-
red hole
(B)
.
