1-19 (E)
WLL-CA55
Hold the connector to remove.
OK
Do not attempt to remove by pulling
the cables.
NG
CN-2494 board
CN-2495 board
CN2
Fine pitch coaxial cables
CN2
6.
Pull out the CN-2494/2495 board as shown in the
figure, and disconnect the fine pitch coaxial cable from
the connector CN2 on the CN-2494/2495 board.
n
Be careful not to bend the fine pitch coaxial cables.
This shortens the wire life.
When disconnecting the fine pitch coaxial cable, do
not attempt to remove by pulling the cable. Be sure to
hold the connector to remove.
7.
Attach the new 68-pin connector (CN-2494/2495
Board) in the reverse order of removal.
m
.
When connecting the fine pitch coaxial cable, hold
the connector, and align the polarity marks. Then
connect the fine pitch coaxial cable to the connector
straight.
.
Check the arrangement of the harness (CAM MIC)
before reattaching the L panel assembly.
(Refer to Section 1-7.)
Hold the conector to connect.
OK
Not to bend the cable.
NG
Polarity marks
