32
Connection Examples
Confirming the System
Construction
After all the connections are complete, confirm that
equipment of the system is properly setup.
1
Connect the AC cords of all equipment to the AC
outlets and turn the power on.
Set the POWER switch of this projector to ON.
2
Press the SYS SET key.
Information on the system construction and the
settings of the interface boards, etc. are
automatically confirmed. Then the message
disappears.
Note
When you want to use the projector without
connecting the switcher after using the switcher in the
system connections, it is necessary to confirm the
system construction again by pressing the SYS SET
key after all the connections are complete. If you press
the key(s), “Master Switcher not exist” appears, but
the system construction is automatically recognized.
Remedy
Set the switcher that outputs
the signal to the projector to
number 1.
Change either number of the
projectors that have the same
number.
Change either number of the
switchers that have the same
number.
When a system error is detected
The following messages are displayed on the screen
and the message display window on the rear of the
projector:
Message
Master Switcher not exist.
Same DEVICE INDEX for
Projector detected.
Same DEVICE INDEX for
Switcher detected.
Note
If the projector is in standby mode, the message in
English appears only in the message display window.
