Sony VPD-LE100, Operating Instructions Manual

Page: 20 / 44

20
0 0
CONTOROL S
IN
PLIG IN POWER
STATUS/ERROR MESSAGE
OUT
STANDBY
1
ON
@
RS-
232C
RS-
422A
RS-232C/422A PJ COM IN
R G/G SYNC SYNC/HD VD B
OUT
TRIG DEVICE INDEX CONTOROL
STATUS/ERROR MESSAGE
IN
PLIG IN POWER
OUT RS-
232C
RS-
422A
RS-232C/422A PJ COM IN OUT
STANDBY
1
ON
@
0 0
CONTOROL S TRIG DEVICE INDEX CONTOROL
SELECT
VIDEO MEMORY
SWITCHER INDEX
PIC ON AUDIO OFF
PATTERN FOCUS ZOOM SHIFT
NORMAL
MUTING STATUS
LCD LENS CONTROL
ON
COMMAND
OFF
SIZE DOT PHASE
APA
SHIFT
RGB
R
B
CENT
ON STANDBY
MEMORY MENU
VIDEO
INPUT SELECT
A D B C
BLKG SYS SET RESET PUNCTION
1 4 2 3
5 8 6 7
9 10/0(ALL)
SW NO/
OFF/GBOUP
SWITCHER/VIDEO MEMORY /INDEX NO
ENTER
POSITION BRIGHT CONTR
PICTURE CONTROL
HUE COLOR SHARP VOLUME
VIDEO/S VIDEO
LIGHT
ON ON
Projecting
Projecting
Rear remote control detector
STANDBY indicator
ON indicator
1
2
4
3
4
1
Set the POWER switch on the front of the
projector to ON.
The STANDBY indicator lights in red and the
projector enters the standby mode.
2
Press the ON key.
The ON indicator lights in green.
3
Turn on the power of equipment connected to the
projector. Press the INPUT SELECT keys to select
the input source.
A:
Selects the signal input from the INPUT A
connectors.
B: Selects the signal input from the connectors on
the optional interface board which is installed in
the INPUT B section.
C:
Selects the signal input from the connectors on
the optional interface board which is installed in
the INPUT C section.
D: Selects the signal input from the connectors on
the optional IFB-LE100 interface board which
is installed in the INPUT D section.
Note
When you select the input signal connected to the
INPUT A, INPUT B, INPUT C or INPUT D
section, be sure to select the correct signal type on
INPUT-A, INPUT-B, INPUT-C or INPUT-D of
the SIGNAL SELECT menu. If an incorrect signal
type is selected, picture may be distorted.
For details, see “The SIGNAL SELECT Menu” on page
28.
When you input the signal from equipment
connected to the PC-3000 Signal Interface
Switcher (not supplied)
Set the SWITCHER/VIDEO MEMORY/INDEX
select switch on the Remote Commander to the
SWITCHER position and press the number keys 1
to 8 to select the input. When multiple switchers
are connected, press the SW NO/OFF/GROUP
key, then select the switcher number and the input
number.
STANDBY key
MUTING PIC key
SW NO/OFF/GROUP key
SWITCHER/VIDEO MEMORY/
INDEX select switch
Control panel (on the top)