Sony UP-DR200, Service Manual, Page: 14 / 102

1-8
UP-DR200
1-6-3. Paper Holder (Main) Assembly
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly/side panel (L)
assembly. (Refer to Section 1-4-2.)
3. Remove the paper door assembly.
(Refer to Section 1-6-2.)
4. Remove the paper guide roller.
5. Remove the two hooks, then remove the paper holder
(MB).
6. Remove the eight screws, then remove the four oil
damper.
7. Push the arm lock plate (L) subassembly and arm lock
plate (R) subassembly in the direction of the arrow,
then place the paper arm (L) subassembly and paper
arm (R) subassembly in the chassis.
n
If this is not performed, the paper holder may be
damaged when the paper holder (main) assembly is
removed.
8. Remove the three screws (BVTT3
x
6) and six screws
(BTP3
x
10), then pull out the paper holder (main)
assembly slowly while pushing the paper arm shaft in
the direction of the arrow.
m
.
Be careful when removing the paper holder (main)
assembly to prevent the paper arm shaft from
coming off the paper holder assembly because it is
not fixed.
.
When removing the paper holder (main) assembly,
make sure that the door lock cam position is as
shown in the illustration.
Paper guide roller
Paper holder (MB) assembly
Hooks
9. Attach the paper holder (main) assembly in the reverse
order of steps 1 to 8.
BVTT
3
x
6
BVTT
3
x
6
BTP
3
x
10
BTP
3
x
10
PS2
x
5
PS2
x
5
Oil damper
Oil damper
Paper arm (L)
subassembly
Paper arm (R)
subassembly
Chassis
Paper arm shaft
Paper holder (main)
assembly
X
Door lock cam
Door lock cam
Arm lock plate (L)
subassembly Arm lock plate (R)
subassembly
Paper arm shaft