MEX-N5100BE/N5100BT/N5150BT
25
3-5. MAIN BOARD
3-6. ANTENNA BT (BT1)
2
two ground point screws
(PTT2.6
u
6)
5
Remove the
MAIN board block
in the direction
of the arrow.
3
screw
(PTT2.6
u
8)
3
screw
(PTT2.6
u
8)
4
claw
4
claw
1
lead wire with connector
(CN1002)
OK
NG
connector
connector
lead wire with connector
lead wire with connector
:LUHVHWWLQJ
lead wire from antenna BT
antenna BT
front side
MAIN board
white line
connector
(CN1002)
heat transfer sheet
guide
line
Note 3:
The heat transfer sheet must be
pasted on this position.
However, when the MAIN board
block is removed, the heat transfer
sheet may adhere to the MAIN
board.
Paste the heat transfer sheet on
this place again then.
Note 2:
Arrange the lead wire
along a white line.
2
screw (T)
3
antenna BT
(BT1)
1
lead wire with connector
(CN1002)
OK
NG
connector
connector
lead wire with connector
lead wire with connector
:LUHVHWWLQJ
lead wire from antenna BT
antenna BT
front side
MAIN board
white line
connector
(CN1002)
Note:
Arrange the lead wire
along a white line.
Note 1:
When the complete MAIN board is replaced, it is necessary to replace knob (VOL) (SV)
assy simultaneously. Also, the destination setting, Bluetooth operation check and Bluetooth
information writing is necessary. Refer to “DESTINATION SETTING METHOD” on page
4, “BLUETOOTH FUNCTION CHECKING METHOD USING A CELLULAR PHONE”
on page 7 and “BLUETOOTH INFORMATION WRITING METHOD” on page 8.