Sony MDR DS5000, Operating Instructions Manual

Page: 10 / 116

10
GB
Preparation
Rubber supports
To use on its side:
Place the digital surround processor so that the four rubber supports are on the
bottom.
Notes
• If the digital surround processor is placed on its side, the full infrared transmission range may
not be obtained for some installation conditions.
• Place the digital surround processor as shown in the illustration. Do not place the digital
surround processor on the side not having the rubber supports.
Connecting the digital surround processor with digital
components
Use the supplied optical digital connecting cable to connect the optical digital output
jack on a DVD player (or LD player), digital satellite tuner, or other digital component
to the DIGITAL IN jack of the digital surround processor.
/
To DIGITAL IN jack
Digital surround
processor
DVD player, LD player, digital
satellite tuner, or other digital
component having an optical
digital output jack
To optical digital
output jack
Optical digital connecting cable (supplied)
Take off the cap on the jack, match the orientation of the plug
with the jack, and then insert until the plug fits into place.
Notes
• The optical digital connecting cable is an extremely high-precision device and is sensitive to
jolts and external pressure. Therefore, be careful when inserting and removing the cable plug.
• This system is not compatible with the AC-3 RF jacks on LD players.
• The digital input for the digital surround processor does not support sampling frequencies of
96 kHz. Set the digital output setting for the DVD player at 48 kHz when using this system.
Noise may be heard when a 96-kHz digital signal is input.
• The digital input for the digital surround processor is not compatible with the DTS
*
format.
Noise may be heard when DTS-format signals are input.
*
DTS is a trademark of Digital Theater Systems (USA).