Sony LSM-100, Operating Instructions Manual

Page: 37 / 53

33
Projector Control
Cha
p
te
r 2
Us
er
Gu
ide -
R
2
2
0
minimum of 10 minutes. This additional time is
required to allow the projector lamp to achieve
operating temperature and stabilize.
Note: Usable Lamp life will be diminished by
unnecessarily turning the Lamp On and then Off. Also,
once
Lamp ON is selected the lamp should be allowed
to operate for some minutes to allow the lamp to come
completely to operating temperature before turning it
off.
DO NOT REMOVE AC MAINS POWER TO SHUT
DOWN THE SYSTEM AS COOLING WILL BE LOST
TO THE PROJECTOR AND LAMP.
Douse the Projector
The DOUSER control function in the PROJECTOR
CONTROL screen serves the same purpose as the
“douser” on the film projector. In fact it works in much the
same way by placing a opaque blade in the output light
path.
When you set the projector DOUSER to ON the
auditorium screen goes dark. However, this only applies to
the image portion of the presentation. The audio portion of
the presentation continues and must be muted using the
Muting control on the Media Block screen.
• Douser ON (Closed)
The DOUSER control is an alternate action button
whose current state is indicated by the status label and
a status indicator in the
OFF/ON button. When the
control’s status indicator is out (label shows OFF) the
the douser is open and the current presentation (image)
appears on the auditorium screen.
To douse the projector output, tap Menu , tap
Projector Control and then, in the DOUSER block,
tap the alternate action OFF /ON button. The projector
output is doused, the auditorium screen goes dark and
the control button label changes to ON and its status
indicator is lit (see inset in illustration). The Projector
Lamp remain energized ON).
• Douser OFF (Open)
The projector Douser is activated by an alternate
action control button whose current state is indicated
by the status indicator located in the
ON/OFF button.
When the indicator is illuminated (label shows ON)
the projector DOUSER is closed and the auditorium
screen is dark.
To restore the projector output (open the “douser”), tap
Menu , tap Projector Control and then, in the
DOUSER block, tap the alternate action ON /OFF
button. The projector output is restored, the auditorium
screen is illuminated, the control button label changes
to OFF and the button status indicator is dark.
Change Projector Function
Changing the Current FUNCTION selection (F1 to F20) is
is done using Change FUNCTION on the PROJECTOR
CONTROL screen. Functions can be used to recall stored
settings which effect the projector setup. Each
FUNCTION configuration is set using the SRX
Controller
1
application and is set to optimize the on-screen
presentation. In addition, a limited number of settings
associated with a specific FUNCTION can be configured
using the
FUNCTION SETUP screen
The configurations are stored and available on a pop-up
accessed from the Projector Control screen. These are
single button FUNCTION selections. In addition, a
FUNCTION can be associated with a SPL or CPL using
the SMS Controller application. In this way the same
configuration is recalled whenever the associated Content
Element is presented.
DOUSER
OFF/ON
1.The SRX Controller exercises direct control over
the projector and therefore should not be used at the
same time the Projectionist Terminal or SMS Control-
ler is in operation.