10
Projector Control
Ch
ap
te
r
1
Us
er Guide
- R1
1
0
the presentation continues and must be muted using the
Muting control on the Media Block screen.
• Douser ON (Closed)
The
DOUSER
control is an alternate action button
whose current state is indicated by the status label and
a status indicator in the
ON/OFF
button. When the
control’s status indicator is out (label shows OFF) the
the douser is open and the current presentation (image)
appears on the auditorium screen.
To douse the projector output, tap
Menu
, tap
Projector Control
and then, in the DOUSER block,
tap the alternate action
ON/OFF
button. The projector
output is doused, the auditorium screen goes dark and
the control button label changes to ON and its status
indicator is lit (see inset in illustration). The Projector
Lamps remain energized ON).
• Douser OFF (Open)
The projector Douser is activated by an alternate
action control button whose current state is indicated
by the status indicator located in the
ON/OFF
button.
When the indicator is illuminated (label shows ON)
the projector DOUSER is closed and the auditorium
screen is dark.
To restore the projector output (open the “douser”), tap
Menu
, tap
Projector Control
and then, in the
DOUSER block, tap the alternate action
ON/OFF
button. The projector output is restored, the auditorium
screen is illuminated, the control button label changes
to OFF and the button status indicator is dark.
Select Projector Function
Seven FUNCTION selections (F1 to F7) are available on
the PROJECTOR CONTROL screen and can be used by
you to recall stored settings which effect the projector
setup. Each FUNCTION is configured using the SRX
Controller application and is set to optimize the on-screen
presentation. In addition, a limited number of settings
associated with a specific FUNCTION and be configured
using the
FUNCTION SETUP
screen
The configurations are stored and available on the
Projectionist Terminal as single button FUNCTION
selections. In addition, a FUNCTION can be associated
with a SPL or CPL using the SMS Controller application.
In this was the same configuration is recalled whenever the
associated Content Element is presented.
MANUALLY SELECTING A FUNCTION WILL
CHANGE THE PROJECTOR SETTINGS FOR THE
CURRENT PRESENTAION ONLY.
The FUNCTION selection is made from the PROJECTOR
CONTROL screen. To access the PROJECTOR
CONTROL screen, tap
Menu
and then tape
Projector
Control
. The “FUNCTION” is simply identified as F1
through F7. The “stored value” of these Function settings
are projector related and are used to tailor the projector
output to meet specific presentation requirements for the
CPL.
• Select Function
In the FUNCTION area of the PROJECTOR
CONTROL screen tap the
LEFT ARROW
or
RIGHT ARROW
until the specific FUNCTION
number, e.g., F1, F2, etc., is visible then tap the desired
FUNCTION
button.
Caution:
The projector adjustments and settings
stored as the selected FUNCTION are
immediately
applied to the projector. No confirmation message of
the FUNCTION key selection is required. Also,
there
is no “undo”.
If the previous settings were the results
of a previously applied FUNCTION setting then select
the previous FUNCTION key.
DOUSER
OFF/ON
FUNCTION Select
Summary of Contents for LSM-100
Page 27: ...23 Power ON OFF Chapter 1 User Guide R110 ...
Page 53: ...Sony Corporation ...
