A
d
mini
s
tra
ting
t
he
Came
ra
Sending an Image via mail — e-Mail (SMTP) setting Menu
39
Sending an Image via
mail
— e-Mail (SMTP) setting
Menu
When you click
SMTP
on the Administrator menu, the
SMTP setting menu appears.
By using Mail (SMTP) function, you can send a mail
with attached image file which has been shot linked with
the external sensor input or with the built-in motion
detection function. The image file can also be sent
periodically.
e-Mail (SMTP) setting menu is composed of three tabs:
Common
,
Alarm sending
and
Periodical sending
.
Common Tab — Setting the SMTP
Function
e-Mail (SMTP)
Select
On
when you use the e-Mail (SMTP) function.
The common setting options are displayed below.
If you do not wish to use the e-Mail (SMTP) function,
select
Off
and click
OK
.
Notes
• During transmission of an image file via mail, the
frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera video mode is set to
MPEG4
, the
image of the composite video signal output from the
video output connector of the camera may be distorted
during mail transmission.
• You cannot send an audio file by using the mail
sending function.
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
mail.
None:
Select if no authentication is required when an e-
Mail is sent.
SMTP authentication:
Select if authentication is
required when an e-Mail is sent.
POP before SMTP:
Select if POP before SMTP
authentication is required when an e-Mail is sent.
POP server name
It is necessary when the
POP before SMTP
is selected
in
Authentication
.
Type the POP (receiving mail) server name up to 64
characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends
e-Mails performs authentication using the POP user
account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-Mails performs
authentication.
Recipient e-Mail address
Type the recipient e-Mail address up to 64 characters.
You can specify up to three recipient e-Mail addresses.
Administrator e-Mail address
Type the Administrator e-Mail address up to 64
characters.
This address is used for reply mail and sending system
messages from the SMTP server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
When
Alarm sending
of the alarm tab is set to
On
, the
mail sent due to the alarm detection will indicate the
type of alarm in the subject.
SI
is added for sensor input
detection, and
MD
is added for motion detection.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.)
OK/Cancel
