PCS-G70N/G70NP/G70NP2
PCS-G70S/G70SP
4-29 (E)
14. Check that the response status “
0xXX
” is within
specification.
Specification:
0xc0
to
0xd4
15. Enter the following command from the terminal PC,
and check the response status.
command>
vlpc r 405 330
↓
0xXX
16. Check that the response status “
0xXX
” is within
specification.
Specification:
0xd4
to
0xe8
17. Change the connection of the video cable from the
MCU VIDEO OUT 4 connector to the MCU VIDEO
OUT 5 connector, and perform the same check in steps
11 to 16.
18. After checking, enter the following command from the
terminal PC.
command>
videovfp 4 0
↓
command>
cb off
↓
command>
videoin 0 1
↓
command>
videoin 1 0
↓
4-2-9. MCU Video Output Check
1.
Connect the unit’s MAIN AUX IN connector and
MCU VIDEO OUT 1 connector with the S video
cable.
2.
Refer to Section 4-1-2, and start the Diag mode.
3.
Enter the following command from the terminal PC,
and check the response status.
command>
cb cenc5
↓
command>
videoin 0 1
↓
command>
vlpc y 135 330
↓
0xXX
4.
Check that the response status “
0xXX
” is within
specification.
Specification:
0xbf
to
0xe5
5.
Enter the following command from the terminal PC,
and check the response status.
command>
vlpc b 405 330
↓
0xXX
6.
Check that the response status “
0xXX
” is within
specification.
Specification:
0xc0
to
0xd4
7.
Enter the following command from the terminal PC,
and check the response status.
command>
vlpc r 405 330
↓
0xXX
8.
Check that the response status “
0xXX
” is within
specification.
Specification:
0xd4
to
0xe8
9.
Change the connection of the S video cable from the
MCU VIDEO OUT 1 connector to the MCU VIDEO
OUT 2 and 3 connectors, and perform the same check
in steps 3 to 8 for each one.
10. Disconnect the S video cable, and connect the unit’s
SUB AUX IN and MCU VIDEO OUT 4 connectors.
11. Enter the following command from the terminal PC,
and check the response status.
command>
videoin 1 1
↓
command>
videovfp 4 1
↓
command>
vlpc y 135 330
↓
0xXX
12. Check that the response status “
0xXX
” is within
specification.
Specification:
0xbf
to
0xe5
13. Enter the following command from the terminal PC,
and check the response status.
command>
vlpc b 405 330
↓
0xXX