PCS-G70N/G70NP/G70NP2
PCS-G70S/G70SP
4-28 (E)
4-2-8. Video Input Check
1.
Refer to Section 4-1-2, and start the Diag mode.
2.
Refer to steps (1) and (2), and input the color-bar
signal to the MAIN AUX IN connector of the unit.
(1) Connect the unit’s MAIN AUX IN and VIDEO
OUT AUX connectors using the video cable with
a connector (supplied accessary).
(2) Enter the following command from the terminal
PC, and check the response status.
command>
cb cenc
↓
Color Bars on VOA( 1, 2 ) CENC screen
3.
Enter the following command from the terminal PC,
and check the response status.
command>
videoin 0 2
↓
command>
vlpc y 135 330
↓
0xXX
4.
Check that the response status “
0xXX
” is within
specification.
Specification:
0x98
to
0xb6
5.
Enter the following command from the terminal PC,
and check the response status.
command>
vlpc b 405 330
↓
0xXX
6.
Check that the response status “
0xXX
” is within
specification.
Specification:
0xa9
to
0xbd
7.
Enter the following command from the terminal PC,
and check the response status.
command>
vlpc r 405 330
↓
0xXX
8.
Check that the response status “
0xXX
” is within
specification.
Specification:
0xb7
to
0xcf
9.
Change the connection of the video cable with a
connector (supplied accessary) from the MAIN AUX
IN connector to the SUB AUX IN connector.
10. Enter the following command from the terminal PC.
command>
videoin 1 2
↓
command>
videovfp 4 1
↓
11. Perform steps 3 to 8.
12. After checking, enter the following command from the
terminal PC.
command>
videovfp 4 0
↓
command>
cb off
↓
command>
videoin 0 0
↓
command>
videoin 1 0
↓
4-2-7. Camera Input Check
1.
Connect the MAIN CAMERA connector of the unit
and the camera.
2.
Refer to Section 4-1-2, and start the Diag mode.
3.
Enter the following command from the terminal PC.
command>
videoin 1 1
↓
4.
Check that the picture, from the camera connected to
the MAIN CAMERA connector from the VIDEO
OUT AUX and VIDEO OUT MONITOR1/2 connec-
tors, is output.
n
Connect the VIDEO OUT AUX connector and the
monitor with the video cable, and connect the VIDEO
OUT MONITOR1/2 connector and the monitor with
the S video cable.
5.
Change the connection of the camera from the MAIN
CAMERA connector to the SUB CAMERA connec-
tor.
6.
Enter the following command from the terminal PC.
command>
videoin 0 1
↓
command>
videoin 1 0
↓
7.
Check that the picture, from the camera connected to
the SUB CAMERA connector from the VIDEO OUT
AUX and VIDEO OUT MONITOR1/2 connectors, is
output.
8.
After checking, enter the following command from the
terminal PC.
command>
videoin 0 0
↓
