105
2-13. DD-1020 Board
Preparation
1. Remove the top cabinet and the bottom cover. (Refer to “2-2. Top Cabinet, Bottom Cover”.)
2. Remove the inside panel. (Refer to “2-3. Inside Panel”.)
3. Remove the outside panel. (Refer to “2-4. Outside Panel”.)
4. Remove the VC-1046 board. (Refer to “2-5. VC-1046 Board”.)
5. Remove the CK-1027 board. (Refer to “2-8. CK-1027 Board”.)
6. Remove the VF-1024 board. (Refer to “2-10. VF-1024 Board”.)
7. Remove the rear assembly. (Refer to “2-12. Rear Assembly”.)
Procedure
1. Disconnect the two harnesses from the connectors (CN1001, CN1002) on the DD-1020 board.
2. Remove the three screws, and then remove the DD-1020 board.
3. Remove the DD shield case from the DD-1020 board.
Note
After installing the DD shield case, make sure that the DD shield case is inserted all the way into the
all clips.
4. Install the removed parts by reversing the steps of removal.
P1.7 x 3
Hole
Hole
CN1001
DD-1020 board
Harnesses
Boss
Boss
CN1002
DD-1020 board
Clips
DD shield case