71
3. Open the REMOTE terminal cover, and then remove the four screws.
4. Release the hook, and then remove the outside panel.
Note
When installing the outside panel, observe the following instructions.
•
Before and after installing the outside panel, make sure that the two silicon tubes are properly
attached.
•
Arrange the coaxial cable as shown in the figure, be careful not to pinch the coaxial cable.
•
Push the outside panel in the direction of the arrow and tighten the rear side screw.
5. Install the removed parts by reversing the steps of removal.
Outside panel
Outside panel
Silicon tube
Silicon tube
Groove
Notch
Hook
Pushing directions
Arrangement of coaxial cable
P2 x 4
REMOTE terminal cover
Coaxial cable
Hook
P2 x 4
Coaxial cable