Sony HT-ST9, Operating Instructions Manual

Page: 37 / 187

37
US
O
ther
Funct
ions
Modifying the Angle of the Bar Speaker
You can modify the angle of the Bar Speaker by attaching the stands
on the bottom of the Bar Speaker.
You can attach the stands on the bottom of the Bar Speaker as
shown below.
 We recommend that you use the system without attaching stands if you
will be listening to High-Resolution Audio.

When you mount the Bar Speaker on the wall, detach the stands
beforehand.
Attach the stands to both sides of the bottom of the Bar Speaker
using the supplied screws.
Tip
The stand shape differs for the right and left sides. Check the “R” or “L”
mark engraved on the stand before attaching it.
Mounting the Bar Speaker on a Wall
You can mount the Bar Speaker on a wall.

When you mount the Bar Speaker on the wall, detach the stands
beforehand (page 37).
 Prepare screws (not supplied) that are suitable for the wall material and
strength. As a plasterboard wall is especially fragile, attach the screws
securely to two studs in the wall beam. Install the Bar Speaker
horizontally, hung by screws in studs in a continuous flat section of the
wall.
 Have the installation done by a Sony dealer or licensed contractor and
pay special attention to safety during the installation.

Sony shall not be held responsible for accidents or damage caused by
improper installation, insufficient wall strength, improper screw
installation or natural disaster, etc.
1
Prepare screws (not supplied) that are suitable for the holes
on the rear of the Bar Speaker.
Notes
Screw
Stand
Notes
Hole on the rear of the Bar Speaker
4 mm (3/16 in)
More than 30 mm (1 3/16 in)
4.6 mm
(3/16 in)
10 mm
(13/32 in)
continued